Isys iTerra Elite Color LED Printer Manual de usuario descargar pdf (Pagina 25)

_________________________________________________________________________________________________________________________

III. NETWORK INSTALLATION

C. Network Port Connection

1) Turn the printer off.

2) Connect your Ethernet cable to the network port on the printer (1).

3) Connect the other end of the Ethernet cable to the network port, Hub or host system (2).

4) Turn the printer on and wait for the print server status light (3) to stop blinking.

If you are unaware of what the network IP set value is for the printer, follow the instructions below to determine that value.

You will need to know the printer IP before you can load the printer driver.

If a network configuration card is not already installed refer to Trouble Shooting Chapter and/or Accessory installation (if

network card is purchased later than printer).

NOTE:

Ethernet® cable is not supplied with the printer. Use an Ethernet cable with two twisted wire pairs and an

RJ45 plug.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 118 119

Sin comentarios

Isys iTerra Elite Color LED Printer Manual de usuario Pagina 25